Adaptec GDTSETUP Manual de instalación descargar pdf (Pagina 54)

Last status:

The Last Status gives detailed information on the last failure of a hard disk.

The information is only present until the next hard reset of the system and may help for

deeper failure analysis or tracing.

The following listed messages are part of the SCSI documentation. Format:

[""""\]

(???? = additional device specific messages)

[""""K

NO SENSE. Indicates that there is no specific sense key information to

be reported for the designated logical unit. This would be the case for

a successful command or a command that received CHECK

CONDITION or COMMAND TERMINATED status because one of the

filemark, EOM, or ILI bits is set to one.

[""""K

RECOVERED ERROR. Indicates that the last command completed

successfully with some recovery action performed by the target. De-

tails may be determinable by examining the additional sense bytes

and the information field. When multiple recovered errors occur dur-

ing one command, the choice of which error to report (first, last, most

severe, etc.) is device specific.

[""""K

NOT READY. Indicates that the logical unit addressed cannot be ac-

cessed. Operator intervention may be required to correct this condi-

tion.

[""""K

MEDIUM ERROR. Indicates that the command terminated with a non

recovered error condition that was probably caused by a flaw in the

medium or an error in the recorded data. This sense key may also be

returned if the target is unable to distinguish between a flaw in the

medium and a specific hardware failure (sense key 4h).

[""""K

HARDWARE ERROR. Indicates that the target detected a non-

recoverable hardware failure (for example, controller failure, device

failure, parity error, etc.) while performing the command or during a

self test.

[""""K

ILLEGAL REQUEST. Indicates that there was an illegal parameter in

the command descriptor block or in the additional parameters sup-

plied as data for some commands (FORMAT UNIT, SEARCH DATA,

etc.). If the target detects an invalid parameter in the command de-

scriptor block, then it shall terminate the command without altering

the medium. If the target detects an invalid parameter in the addi-

tional parameters supplied as data, then the target may have already

altered the medium. This sense key may also indicate that an invalid

IDENTIFY message was received (6.6.7).

[""""K

UNIT ATTENTION. Indicates that the removable medium may have

been changed or the target has been reset. See 7.9 for more detailed

information about the unit attention condition.

[""""K

DATA PROTECT. Indicates that a command that reads or writes the

medium was attempted on a block that is protected from this opera-

tion. The read or write operation is not performed.

[""""K

BLANK CHECK. Indicates that a write-once device or a sequential ac-

cess device encountered blank medium or format-defined end-of-data

indication while reading or a write-once device encountered a non-

blank medium while writing.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 92 93

Comentarios a estos manuales

Sin comentarios

Adaptec GDTSETUP Manual de instalación Pagina 54

Comentarios a estos manuales

Relacionado con productos y manuales para Software Adaptec GDTSETUP