Adaptec GDTSETUP Manual de instalación descargar pdf (Pagina 13)

BASEDEV=GDTX000.ADD /V

and that the driver GDTX000.ADD is either in the OS/2 or the root directory:

GDTX000.ADD or

\OS2\GDTX000.ADD

If this line is missing you have to add it to your CONFIG.SYS file. If the GDT driver

GDTX000.ADD is not in the OS/2 or root directory, copy it there.

,8VLQJD&'520'ULYHXQGHU26

If OS/2 has been installed from an OS/2 CD, you may skip this chapter as well as chapters

I.4.1 and I.4.2. A CD-ROM drive (standing for any other Not Direct Access Device) can be acces-

sed under OS/2 either directly through the OS/2 driver

OS2SCSI.DMD

, or the OS/2 ASPI

Manager

OS2ASPI.DMD

, or, for example, through corelSCSI for OS/2. We presume that the

CD-ROM drive has been properly connected to the ICP Controller. This includes that the

SCSI-ID and the SCSI bus terminators are set in accordance with the settings of the already

present SCSI devices (i. e., the SCSI-ID set for the CD-ROM drive is not occupied by another

device; resistor terminators are located at the two ends of the SCSI bus only).

,,QVWDOODWLRQZLWK266&6,'0'

6WHS

Click the OS/2 System icon on the OS/2 Presentation Manager. Then select "System

Setup" and then "Selective Install".

6WHS

Confirm the system configuration with "OK".

6WHS

Now click "CD-ROM Device Support" in the window opening and select the CD-ROM

drive. Hereafter click "OK".

6WHS

Click Install now and the installation begins. The system will ask you to insert further

OS/2 system disks or select an appropriate path on the hard disk.

6WHS

After the installation is completed and OS/2 is started again, the CD-ROM drive can

be accessed.

,,QVWDOODWLRQZLWK26$63,'0'

6WHS

Add the following line to the CONFIG.SYS file, using, for example, the OS/2 system

editor: BASEDEV=OS2ASPI.DMD

6WHS

Now the driver GDTX000.ADD has to be configured in a manner that allows only the

ASPI Manager to access the CD-ROM drive (identified by its SCSI-ID, which in our example

is SCSI-ID 6): BASEDEV=GDTX0000.ADD /V /A:0 /AM:(0,6)

(an exact description of the command line switches can be found in the next chapter, I.5).

6WHS

Now install the corelSCSI software from the corelSCSI OS/2 floppy disk.

6WHS

After the restart of OS/2, the CD-ROM drive can be accessed.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 92 93

Comentarios a estos manuales

Sin comentarios

Adaptec GDTSETUP Manual de instalación Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Software Adaptec GDTSETUP