Adaptec GDT RN Series Manual de usuario descargar pdf (Pagina 46)

SE/LVD Terminator for SE/LVD hard disks with SCA connector.

B.4.5 Examples

On the following pages, are some examples of correct SCSI cabling.

First of all a few general tips:

 All ICP Controllers have a yellow LED for each Wide/Ultra2 and Ultra 160 SCSI channel.

This LED indicates the current SCSI-Mode of the corresponding channel. If the LED is

lit, the Wide/Ultra2 and Ultra 160 SCSI channel is operating in LVDS-Mode.

If the LED is not lit, this channel is operating in SE-Mode only.

(The same applies to the SCSI accessories Art.No.: 8951 and 8952. There are two LEDs

indicating the current SCSI-Mode: Green=SE, Yellow=LVDS).

 If you want to use hot-swap shelfs for LVD disk drives, make sure that the shelf is fully

LVD compliant, especially when several shelfs are operated on one LVD channel. When-

ever possible use for both, the shelf and the LVD disk drive, the SCA connector.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 185 186

Sin comentarios

Adaptec GDT RN Series Manual de usuario Pagina 46