Adaptec AMM-1510M Guía de usuario descargar pdf (Pagina 38)

2-16

AMM-1525M/1510M/525M User’s Guide

Stock Number: 510660-00, Rev. A Page: 2-16

Print Spec Number: 492932-00

Current Date: 9/20/94 ECN Date: 9/27/94

Connecting IDE Devices (AMM-1525M/525M Only)

IDE devices (standard IDE hard disk drives and/or ATAPI CD-ROM

drives) are connected to the host adapter by a 40-pin IDE ribbon

cable with a 40-pin header connector. The host adapter has a single

IDE connector for cabling up to two IDE devices. See Chapter 3, IDE

Configuration for configuring IDE devices.

The 40-pin IDE ribbon cable included in your kit has connectors at

each end. One end of the cable is attached to the 40-pin IDE connec-

tor on the host adapter, and the other end is attached to an IDE

device.

To connect a second IDE device, obtain a 40-pin IDE ribbon cable

with a middle connector.

Note: If you are using the AMM-1525M/525M as the only

IDE controller in your computer, you must disable any exist-

ing IDE controller in the computer; see your computer’s

documentation.

To connect IDE devices to the AMM-1525M/525M, follow these

steps:

1 Set the first IDE device as the master device and the second (if

any) as the slave device. See your IDE device documentation

for details.

2 Attach the connector at one end of the 40-pin IDE ribbon cable

to the AMM-1525M/525M IDE connector. Make sure to align

pin 1 of the cable with pin 1 of the connectors on the host

adapter and IDE device.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 73 74

Sin comentarios

Adaptec AMM-1510M Guía de usuario Pagina 38