Adaptec RAID 2810SA Guía de usuario descargar pdf (Pagina 61)

A-8

Adaptec RAID Configuration Utility

Specify whether you want to enable write caching for the array.

When you are finished, select

Done

Initializing Disk Drives

If an installed disk does not appear in the disk selection list for

creating a new array or if it appears grayed out, you need to

initialize it before you can use it as part of an array.

Caution: Initializing a disk overwrites the partition table on the

disk and makes any data on the disk inaccessible. If the drive

is used in an array, you may not be able to use the array again.

Do not initialize a disk that is part of a boot array. The boot

array is the lowest numbered array (normally 00) in the List of

Arrays dialog box. (See Viewing Array Properties on page A-3

for information on determining which disks are associated

with a particular array.)

To initialize drives:

1 At the BIOS prompt, press Ctrl+A.

2 From the ARC menu, select Array Configuration Utility.

3 Select Initialize Drives.

4 Browse with the arrow keys to select a channel.

5 Browse with the arrow keys to highlight the disk you wish to

initialize and then press Insert.

6 Repeat step 5 until all the drives to be initialized are selected.

7 Press Enter.

8 Read the warning message, ensure that you have selected the

correct disk drives to initialize, and then press Y to continue.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 152 153

Sin comentarios

Adaptec RAID 2810SA Guía de usuario Pagina 61