Adaptec RAID 2810SA Guía de usuario descargar pdf (Pagina 31)

3-5

Installing the Driver

Linux

The controller supports Red Hat and SuSE Linux versions as described

in the table below

Notes

■ If you do not find your kernel version listed above, either of the

following conditions may apply:

■ Your kernel contains embedded drivers

■ Drivers are not available and you need to create a custom

driver.

■ For the most up-to-date information on Adaptec’s support of

Linux, visit

www.adaptec.com.

Installing the Driver in a New Red Hat System

In this scenario, you are installing the controller in a new Red Hat

Linux system. To install the driver:

1 Install and configure the controller and hard drives according to

the instructions in Chapter 2.

2 Turn on the computer. During startup, press Ctrl+A to start the

ARC utility. Use the ARC utility to create the array. For details,

see Checking Your Controller and Devices on page 2-3.

3 Insert the Red Hat CD Disk 1 in the CD drive.

4 Restart the computer.

5 When the Red Hat Welcome screen appears, type

expert

at the

boot prompt.

Operating System Version Kernel Version

Red Hat 8.0 2.4.18-14

9.0 2.4.20-6

Advanced Server 2.1 2.4.9-e.3

SuSE 8.1 2.4.19

8.2 2.4.20

Enterprise Server 8

2.4.19-4GB

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 152 153

Sin comentarios

Adaptec RAID 2810SA Guía de usuario Pagina 31