Adaptec 2910C - AHA Storage Controller Fast SCSI 10 MBps Manual de usuario descargar pdf (Pagina 181)

7-11

SCO UnixWare Installation

Troubleshooting

Problems and Solutions

My computer crashes or displays panic messages during the bootup procedure!

You may have to boot from the backup kernel created earlier, and

then perform the driver update procedure again.

To boot from the old kernel, follow these steps:

Reboot the computer.

At the Booting UNIX System… prompt or loading UnixWare

graphics, press the Spacebar.

From the [boot]# prompt, first type KERNEL=old kernel (e.g.,

KERNEL=unix.work) and press Enter. Then, type go and press

Enter. Your computer should now boot from the backup kernel

created earlier in Installing the Driver When SCO UnixWare is

Already Installed on page 7-3.

To repeat the driver update procedure, follow these steps:

Follow the instructions in Removing the Driver on page 7-9 to

delete the driver from your computer.

Perform the driver update procedure again. See Installing the

Driver When SCO UnixWare is Already Installed on page 7-3.

Error Messages

The error messages listed below are the messages associated with

the drivers. Messages are listed sequentially according to the last

three digits of the error code. For example, [xxxxx020], [xxxxx021],

[xxxxx022], etc.

Note:

When reporting problems to Customer Support, be

sure to include the complete error code in your problem

description.

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 189 190

Sin comentarios

Adaptec 2910C - AHA Storage Controller Fast SCSI 10 MBps Manual de usuario Pagina 181