Adaptec 2910C - AHA Storage Controller Fast SCSI 10 MBps Manual de usuario descargar pdf (Pagina 123)

4-7

Novell NetWare Installation

Using the Load Command Line Options

You can specify several command line options when the driver is

loaded. The available options are described in the tables below. The

first table describes the command line options for the

aic7870.dsk

driver for Ultra SCSI and earlier products. The second table

describes command line options for the

aic78u2.ham

driver for

Ultra2 SCSI products.

Table of aic7870.dsk Command Line Options:

Option Values Default Description

auto_bus_fairness= on, off on Enables/disables auto

SCSI bus fairness

algorithm.

auto_disable_tagq= on, off on Enables/disables auto

disable tag queuing

algorithm.

auto_flush_diskreq= on, off on Enables/disables auto

disk flush algorithm.

cdrom= on, off on Enables/disable driver

support for CD-ROM

devices; on = Driver, off =

ASPI.

dev_enable= 00-FFFF FFFF Allows you to enable the

driver's registration of

SCSI devices on a per

target basis. By default, all

targets are scanned. A bit

value of 0 causes the target

not to register under the

operating system. These

devices are still accessible

via ASPI. This enable bit

mask is entered in hex (see

Bit Mask Options

page 4-12).

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 189 190

Sin comentarios

Adaptec 2910C - AHA Storage Controller Fast SCSI 10 MBps Manual de usuario Pagina 123