Adaptec APA-460 Guía de instalación descargar pdf (Pagina 31)

3-3

SlimSCSI Adapter Operation

APA-460 Installation Guide

Stock Number: TR510070-00, Rev. B Page: 3-3

Print Spec Number: TR490120-00

Current Date: 3/25/94 ECN Date: 4/5/94

▼ ▼ ▼ ▼

Notes on SCSIworks! Software Installation

Note: Make sure you have installed CardSoft software (if

Card and Socket Services software is not already installed)

before you install SCSIworks! software. See Appendix A,

Card and Socket Services Installation.

Here are a few brief notes on installing SCSIworks! software.

1 Insert SCSIworks! diskette #1 and type a:\install.

2 Load the software as explained in the SCSIworks! Software Users

Guide.

Operation

Make sure the SlimSCSI is attached and the devices are connected to

it and turned

ON at bootup, especially for CD-ROM or hard disk

drives. This allows the device drivers to load. However, if you are

using tape drives, it is not necessary to have them installed at

bootup because they work directly through the ASPI manager and

not through a device driver.

Once you have installed SCSIworks! software you may remove and

insert the SlimSCSI adapter at any time except when data is being

transferred via the SCSI bus and SlimSCSI adapter; the device busy

light is

ON when data is being transferred.

If the SlimSCSI adapter is not installed when you try to access a

device connected to it, you will receive a message similar to Read

Fault Error Reading Drive X. Reinsert the SlimSCSI adapter into the

PCMCIA socket. It will work correctly if no changes have been

made to the SCSI configuration.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 57 58

Sin comentarios

Adaptec APA-460 Guía de instalación Pagina 31