Adaptec GDTSETUP Manual de usuario descargar pdf (Pagina 152)

152

6WHS

When connecting the various SCSI devices to the SCSI channel of the ICP Control-

ler, please ensure that the SCSI-ID of all Not-Direct-Access devices (e.g., CD-ROM, DAT-

Streamer, MO-drive, etc.) are adjusted to a value greater than or equal to 2. This applies as

well for the CD-ROM drive from which Windows NT is installed.

)7KH,QVWDOODWLRQ

First of all, make sure that you have verified or carried out all steps described in section F.3.

)7KH,&3&RQWUROOHULVWKHRQO\&RQWUROOHULQWKH6\VWHP

The following instructions 1.) to 12.) assume that the ICP Controller is the only controller in

the system and that the operating system is booted from its first Host Drive.

1. Insert the first Windows NT setup disk (Disk #1) into the boot floppy disk drive and reset

the system. After a while you are asked to insert Disk #2.

2. Select:

6 6NLS'HWHFWLRQ

3. Select:

6 6SHFLI\$GGLWLRQDO'HYLFH

4. Choose

2WKHU5HTXLUHVGLVNSURYLGHGE\KDUGZDUHPDQXIDFWXUHU

and press <ENTER>

5. Insert the GDT Windows NT Disk.

6. Select the

*'76&6,'LVN$UUD\&RQWUROOHU

and press <ENTER>.

7. Setup tells you that it has recognized the ICP Controller. Press <ENTER> to continue.

8. Insert Disk #3 and press <ENTER>.

9. Now you can adjust the other system configuration parameters of your Windows NT

system (graphics adapter, mouse, etc.).

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 217 218

Sin comentarios

Adaptec GDTSETUP Manual de usuario Pagina 152