- Hot target discovery is not supported for smaller arrays.
Arrays created may not be available to the Linux OS until an
OS reboot.
- Adaptec 2020ZCR/2025ZCR/2020SA/2025SA only --
With the SLES 9.0 64-Bit operating system, you cannot format a
spanned volume of a large size without the operating system
locking up. If this happens, you can do a hard shutdown of the
machine, however,if you try to format again, the operating
system will continue to lock up. WORKAROUND: Disable Adaptec
Storage Manager during Linux format procedure.
8.6 SCO OpenServer 5.06 and 5.07
- Adaptec 2020SA/2025SA/2810SA/21610SA controllers are supported
as secondarycontrollers, but not as bootable controllers on
these operating systems.
8.7 NetWare
- NetWare supports only a single DOS partition.
--------------------------------------------------------------------
9. Motherboards and System-Specific Compatibility Issues
9.1 BBS (BIOS Boot Specification)
- On motherboard BIOSes supporting BBS, BBS support is usually
enabled on the Adaptec controller and could cause problems
during restart. WORKAROUND: Disable BBS.
9.2 ASUS P3C-2000 and P2B
- The Adaptec RAID controllers are not supported in these
motherboards.
9.3 ASUS P4PE
- The system generates many Event 15's even though the system
continues to operate normally. WORKAROUND: To avoid filling up
the event log, delete these events periodically.
9.4 IBM E-Server XSeries 220
- If you install the Adaptec controller in a 64-bit slot and the
on-board SCSI controller is enabled, the system scans the
controller, displays the controller's banner immediately
followed by BIOS NOT INSTALLED, and then freezes.
WORKAROUND: Use a 32-bit slot or disable the on-board SCSI
controller.
9.5 IBM Netfinity 5000
- The system generates many Event 9's even though the system
continues to operate normally. WORKAROUND: To avoid filling up
the event log, delete these events periodically.
Comentarios a estos manuales