Adaptec AAR-2020SA Manual de usuario descargar pdf (Pagina 5)

attempt any other operations while performing a Clear operation

on a SATA array.

- SATA events are displayed with SCSI nomenclature.

- Adaptec 2810SA/21610SA only -- ACU is not supported on these

controllers when installed in the following motherboards:

o SuperMicro P40C6+/P4DCE Server Board, 512 MB DDR RAM

o Intel Xeon x 2 System BIOS rev: 1.26

WORKAROUND: Use Adaptec Storage Manager on the bootable CD to

create arrays.

5.2 SCSI Controllers

- In Linux, the controller does not support attached CD drives

during OS installation.

- Adaptec 2020ZCR/2120S/2200S only -- RAID 10 arrays with greater

than 20 drives and RAID 50 arrays with greater than 18 drives

support the Build/Verify command, but not the Clear command.

- Adaptec 2120S only -- When you flash this controller, the

confirmation message says "Writing 2200S firmware (4MB) to the

Controller..." The model number and size are incorrect. (The

message should say "Writing 2120S firmware (2MB) to the

Controller...") However, the flash process is successful.

--------------------------------------------------------------------

6. Adaptec Bootable CD

6.1 Intel SATA chipset compatibility

- The Adaptec bootable CD will not boot when connected to motherboards

equipped with the Intel ICH5 SATA I/O device.

6.2 Intel 875 chipset and DVD ROM drive compatibility

- The Adaptec bootable CD will not boot when it is inserted in a DVD

ROM drive connected to a motherboard equipped with the Intel 875 chipset.

6.3 Usability Issue

- If you experience problems with your video display or mouse when

you boot from the Adaptec CD, specify your hardware by typing the

following at the command prompt:

bootcd [options] <Enter> or lowres [options] <Enter>

lowres -Forces the Adaptec CD to use a generic framebuffer of

640x480.

fbdev -Forces the Adaptec CD to use a generic framebuffer of

800x600.

options:

1 2 3 4 5 6 7 8 9

Sin comentarios

Adaptec AAR-2020SA Manual de usuario Pagina 5