Adaptec AAA-UDMA Guía de instalación descargar pdf (Pagina 46)

5-4

AAA-UDMA Installation and Hardware Guide

Installing the Driver For a Fresh Installation of Windows

2000

To install the

cdaudma.sys

driver when you are installing Windows

2000, follow these steps:

Start your system with the Windows 2000 Boot CD-ROM in the

CD-ROM drive.

Note:

When using a CD-ROM drive to install Windows 2000

from the bootable CD-ROM, make sure Bootable CD-ROM

support is enabled. This is done through the System BIOS

Setup utility.

Press

when this message is displayed:

Press F6 if you need to install third-party SCSI drivers

Insert the Windows 2000 Driver disk for AAA-UDMA when

the setup prompts you to insert the manufacturer supplied

disk into drive

, and then continue.

Adaptec Array1000UDMA Family Manager Set for Windows

2000

driver will be displayed. Select this driver and continue

with the rest of the Windows 2000 installation.

Your system will reboot once more to finish setting up

Windows 2000.

When the Windows 2000 installation is complete, install

Adaptec CI/O Management Software. Refer to the

Adaptec CI/O Management Software User’s Guide

for instructions

on installing and using the software.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 65 66

Sin comentarios

Adaptec AAA-UDMA Guía de instalación Pagina 46