Adaptec AAA-UDMA Guía de instalación descargar pdf (Pagina 25)

2-11

Installing the Hardware

Configuring the AAA-UDMA

After connecting all devices, reinstall the computer cover and

connect all power cables. Turn on the computer. During BIOS

initialization, the AAA-UDMA BIOS banner should appear on the

screen, and each device connected to the card should be listed. If the

BIOS banner does not appear, see Appendix B,

Troubleshooting

Before installing the drivers and software for the AAA-UDMA

RAID card, you may want to configure card options (e.g., ID and

Parity Checking) for the card and the UDMA drives connected to it

by running the onboard BIOS

Select

utility. To do this press

when

the following prompt appears during BIOS initialization:

Press <F6> for BIOSSelect Utility!

In most cases, it is not necessary to run the BIOS

Select

utility. Should

you need to configure card options, see Appendix A,

Using BIOSSelect

and Disk Utilities

for additional information.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 65 66

Sin comentarios

Adaptec AAA-UDMA Guía de instalación Pagina 25