Adaptec SAS RAID Controllers Guía de instalación descargar pdf (Pagina 29)

Chapter 2 Hardware Installation and Removal 15

▼ To Install the Battery Backup Module

1. Attach an ESD wrist strap.

See “Observing ESD and Handling Precautions” on page 9.

2. Lay the top square piece of packing foam from the ship kit on your work

surface, smooth side up.

3. Take the HBA out of the antistatic bag and set it on the packing foam with the

heat sink facing up.

4. Slightly lift the HBA, and from underneath it, insert three plastic screws from

the BBU kit through the following three mounting holes in the HBA:

■ The bottom left hole. This is about 3 inches from the right edge of the HBA.

■ The bottom right hole. This is about 1 inch from the right edge of the HBA.

■ The top right hole. This is about 1 inch from the right edge of the HBA.

FIGURE 2-4 Installing the Battery Backup Module

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 147 148

Sin comentarios

Adaptec SAS RAID Controllers Guía de instalación Pagina 29