Adaptec 4000SAS Guía de usuario descargar pdf (Pagina 53)

Chapter 7: Installing the Driver and an Operating System ● 53

Installing with Red Hat Linux

Note: You will need your Red Hat installation CD to complete this task.

To install the ICP RAID controller driver while installing Red Hat

Linux:

1 Insert the first Red Hat installation CD.

2 Restart your computer.

3 When the Red Hat Welcome screen appears, type linux dd at the

Boot: prompt.

4 When prompted, insert the driver disk, then select OK.

5 Follow the prompts to set up the environment you want.

6 If you are installing other third-party devices, install them now.

Otherwise, select Done.

7 Complete the Linux installation, following the instructions included

with your operating system.

8 Continue with Managing Your Storage Space on page 60.

Installing with SuSE Linux

To install the ICP RAID controller driver while installing SuSE Linux:

1 Insert the first SuSE installation CD.

2 Restart your computer.

3 When the SuSE installation selection screen appears, choose the type

of installation you want, then press the F6 key to indicate the use of a

driver disk. (If

F6 is not shown on the screen, you may have an older

version of SuSE; press the Alt key instead.)

4 When prompted, insert the driver disk, then press any key to

continue.

5 Follow the prompts to set up the environment you want.

6 If you are installing other third-party devices, install them now.

Otherwise, select Back.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 133 134

Sin comentarios

Adaptec 4000SAS Guía de usuario Pagina 53