Adaptec 2910C - AHA Storage Controller Fast SCSI 10 MBps Instrucciones de operaciones descargar pdf (Pagina 238)

Installation

Installing the Host Adapter

Step 1:

Turn OFF your computer and attached

devices, and then disconnect the power cords.

Step 2:

Touch the metal on the back of your

computer with one hand to discharge any static

electricity. With your other hand, handle the host

adapter by the metal bracket or edges and remove it

from the antistatic bag.

WARNING:

Before you go any further, make sure

you have completed Steps 1 and 2.

Step 3:

Remove the cover from the computer case.

(If necessary, refer to your computer documentation.)

Tip:

If you own a computer tower, lay it on its

side for an easier installation.

Step 4:

Locate an unused PCI expansion slot

(typically white or ivory). Unscrew the slot cover and

set it aside.

Note:

The PCI slot must support 5-volt bus

master data transfers. (See your computer docu-

mentation or contact your vendor.)

Step 5:

Position the host adapter over the PCI slot,

and align the bottom edge to the slot’s opening.

Firmly push the host adapter into the PCI slot, so that

it stands perpendicular to the PCI slot.

Back of

Your Computer

PCI Expansion Slots

(typically white or ivory)

Slot Cover

Bottom Edge

PCI Slot

Opening

1 2 ... 233 234 235 236 237 238 239 240 241 242 243 ... 306 307

Sin comentarios

Adaptec 2910C - AHA Storage Controller Fast SCSI 10 MBps Instrucciones de operaciones Pagina 238