Adaptec 2910C - AHA Storage Controller Fast SCSI 10 MBps Instrucciones de operaciones descargar pdf (Pagina 151)

3 Using the Setup Program

This chapter provides an overview of the Setup program. You can use the Setup program to

change the configuration information and boot sequence for the computer.

✏

NOTE

For reference purposes, you should write down the current Setup settings. When you make

changes to the settings, update this record.

Setup Program Modes

The Setup program has three modes of operation:

• Normal mode for normal operations

• Configure mode for configuring the processor speed and clearing passwords (see Chapter 2 for

how to do both tasks)

• Recovery mode for recovering the BIOS data

The Setup program operating mode is controlled by the setting of the configuration jumper block

J8A1 (see Figure 7). The jumper is set to normal mode at the factory.

Table 1 shows jumper settings for the different Setup modes.

Table 1. Jumper Settings for Setup Program Modes

Mode Jumper Description

Normal 1-2 BIOS uses current configuration and passwords for booting.

Configure 2-3 After the POST runs, Setup starts and displays the Maintenance menu. This menu

displays options for setting the processor speed and clearing passwords.

Recovery None BIOS recovers data from a recovery diskette. Refer to Chapter 4 for information on

recovering the BIOS data during an upgrade.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 306 307

Sin comentarios

Adaptec 2910C - AHA Storage Controller Fast SCSI 10 MBps Instrucciones de operaciones Pagina 151