Adaptec 29320-R SCSI Card Guía de instalación descargar pdf (Pagina 4)

Computers may have vertical or horizontal expansion slots. Refer

to your computer manual to locate the PCI/PCI-X slots. If your

computer is a tower model, lay it on its side to allow for easier

installation of the Adaptec SCSI Card 29320.

Insert the Adaptec SCSI Card 29320 in the 64-bit (or 32-bit) PCI or

PCI-X expansion slot; press down firmly until the card clicks into

place, then replace the slot cover screw. When installed properly,

the card should appear level with the expansion slot, as shown

below.

There are several things you may need to do to your SCSI devices

before you connect them to the Adaptec SCSI Card 29320:

•Check the SCSI IDs

•Set the termination

•Connect the power cables

Since setup can vary from device to device, always refer to the

device’s documentation for specific instructions.

Below are some guidelines for setting SCSI IDs and termination

on your devices.

Be careful when inserting the Adaptec SCSI Card

29320 in a PCI slot. Some 32-bit slots will not accommodate it,

and the card may break if you force it into the slot.

WARNING

STEP 4

SETTING UP SCSI DEVICES

ASC-29320 IG.fm Page 3 Wednesday, August 14, 2002 2:00 PM

1 2 3 4 5 6 7 8 9 ... 13 14

Sin comentarios

Adaptec 29320-R SCSI Card Guía de instalación Pagina 4