Adaptec 29160LP - SCSI Card Storage Controller U160 160 MBps Guía de instalación descargar pdf (Pagina 29)

Configuring the Adaptec SCSI Card 29160 with SCSISelect

■

BIOS Support for Int 13 Extensions—(Default: Enabled) When

set to Enabled, the SCSI card BIOS supports Int 13h extensions

as required by Plug-and-Play. The setting can be either enabled

or disabled if your system is not Plug-and-Play.

Using SCSI Disk Utilities

To access the SCSI disk utilities, follow these steps:

Select the SCSI Disk Utilities option from the menu that

appears after starting SCSISelect. SCSISelect scans the SCSI bus

(to determine the devices installed) and displays a list of all

SCSI IDs and the devices assigned to each ID.

Use the arrow keys to move the cursor to a specific ID and

device, then press Enter.

A small menu appears, displaying the options Format Disk

and Verify Disk Media.

■

Format Disk—Allows you to perform a low-level format

on a hard disk drive. Most SCSI disk devices are preformatted

at the factory and do not need to be formatted again.

Caution:

A low-level format destroys all data on the

drive. Be sure to back up your data before performing

this operation. You cannot abort a low-level format

once it is started.

■

Verify Disk Media—Allows you to scan the media of a

hard disk drive for defects. If the utility finds bad blocks on

the media, it prompts you to reassign them; if you select

yes, those blocks are no longer used. Pressing Esc at any

time aborts the utility.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Sin comentarios

Adaptec 29160LP - SCSI Card Storage Controller U160 160 MBps Guía de instalación Pagina 29