Adaptec 29160LP - SCSI Card Storage Controller U160 160 MBps Guía de instalación descargar pdf (Pagina 22)

Adaptec SCSI Card 29160 User’s Reference

Configuring the

Adaptec SCSI Card 29160

with SCSI

Select

SCSISelect, included with the Adaptec SCSI Card 29160, enables you

to change SCSI settings without opening the computer or handling

the card. SCSISelect also enables you to low-level format or verify

the disk media of your SCSI hard disk drives. The following table

lists the available and default settings for each SCSISelect option.

Note:

The default settings are appropriate for most systems.

Run SCSISelect if you need to change or view current set-

tings, or if you would like to run the SCSI disk utilities. See

the descriptions of each option starting on page 18.

SCSI

Select

Options Available Settings Default Setting

SCSI Bus Interface Definitions:

Host Adapter SCSI ID 0-15 7

SCSI Parity Checking Enabled, Disabled Enabled

Host Adapter SCSI Termination

LVD/SE Connectors Automatic,

Enabled,

Disabled

Automatic

SE Connectors Automatic

Low On/High On

Low Off/High Off

Low Off/High On

Automatic

Boot Device Options:

Boot SCSI ID 0-15 0

Boot LUN Number

0-7 0

SCSI Device Configuration:

Sync Transfer Rate (MBytes/sec) 160, 80.0, 53.4, 40.0,

32.0, 26.8, 20.0,

16.0, 13.4, 10.0,

ASYN

160

Initiate Wide Negotiation Yes, No Yes (Enabled)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 37 38

Sin comentarios

Adaptec 29160LP - SCSI Card Storage Controller U160 160 MBps Guía de instalación Pagina 22