Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Especificaciones descargar pdf (Pagina 48)

Model PDP Series 200 maxDPU4E Hardware Guide

• 9 pin Male to Male Gender Changer, Metso Automation part

#050100

• IOM Reset Cable (10-pin ribbon cable connector with pins 5

and 7 connected together), Metso Automation part #050101

• PC104 to ISA-bus adapter (*) with the following ISA cards:

• VGA video card (*) and a VGA monitor(*)

• Disk-On-Chip card with MS-DOS 6.x or later (*)

• Or, a SCSI HD/floppy controller (*) (Adaptec AHA-

1542B or equivalent) and a small SCSI hard disk

loaded with MS-DOS 6.x or later (*).

• AT-style keyboard (*)

• AT-keyboard to DPU4E header adapter cable (*)

• ISA-bus power supply (*)

CPLD Programming

Set the keyswitch to the offline position. (the mode switch can

remain in the “F” position)

Remove the DPU from the chassis.

Insert the IOM Reset Cable into the BDM connector on the

DPU. It is located near the bottom of the board close to the card

edge fingers. “BDM” is marked on the silkscreen.

Connect Altera Byte Blaster Cable adapter to the PC Parallel

Port. Do NOT use more than 6 feet of a ribbon extension cable.

It is best to use either NO extension cable or as short a cable as is

possible. Insert the ByteBlaster’s 10-pin connector into

connector J8 (“JTAG”) on the DPU with pin 1 (red stripe)

closest to the gold edge fingers (toward the rear of the DPU).

WARNING – If there are errors during programming, try again right

away. If you still get errors, immediately turn off the DPU. Do NOT

let a DPU with an improperly or incompletely programmed CPLD sit

with power on. It is possible to cause hardware damage to the DPU

in this condition. Verify your connections and shorten the PC to

ByteBlaster extension cable and try again. Try inserting a CPLD

Programming Adapter (Metso Automation #181549) between the

DPU’s JTAG connector and the ByteBlaster. NEVER put an

extension cable between the DPU and the ByteBlaster.

Plug the DPU into the chassis for 24V power.

Metso Automation MAX Controls Inc. • 278590 •

A-2

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 57 58

Sin comentarios

Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Especificaciones Pagina 48