Adaptec AVA-1505A Guía de usuario descargar pdf (Pagina 11)

FAQ’s for Actel’s Antifuse FPGA Programming 11

Activator

15. How can I verify that the software driver for the Activator (2/2S) is

configured properly?

Ans. Double-click the device icon located in the Control Panel program group. Look for the “Aspi32”

driver. The driver status must be Started and Automatic.

16. How do I configure the Adaptec AVA-1505A SCSI Card for Windows

95/98?

Ans. To configure the Adaptec AVA-1505 SCSI controller card for Windows 95, refer to the Installing the

1505A Card section of the Activator and APS Programming System - Installation and User's Guide

(www.actel.com/documents/ActivatorUG.pdf.)

17. How do I configure the Adaptec AVA-1505 SCSI Card for Windows NT

4.0?

Ans. To configure the Adaptec AVA-1505 SCSI controller card for Windows NT 4.0, refer to the Installing

the 1505A Card section of the Activator and APS Programming System - Installation and User's Guide

(www.actel.com/documents/ActivatorUG.pdf.)

18. Can I use an existing Adaptec SCSI Controller on a PC?

Ans. You can only use an Adaptec SCSI controller card with Activator 2 or 2S. You cannot use any other

manufacturer's SCSI card. You need to find an appropriate SCSI cable to match your board's external

SCSI connector to the Activator 2 or 2S connector (female DB50 for Activator 2, DB25 for Activator 2S).

IMPORTANT: Activator 2 or 2S must be the last device in the SCSI chain, as Activator 2 and 2S contain

termination resistors. If SCSI ID number 5 is not available on your SCSI bus, set the rotary switch on the

back of your Activator 2 or 2S to an available SCSI ID and invoke the APSW programming software with

an additional parameter, as described below. These examples assume that your Actel software is

installed in the “c:\actel” directory, and that you want to use SCSI ID number 4.

The following procedure is for Windows NT 4.0 and Windows 95.

1. From the main window, right-click Start.

2. Select Open All Users (Open for Windows 95) > Programs > Designer Series 3.1 and click

Windows Programming.

Activator 2/2S and hardware accessories have been discontinued and hence Actel will provide limited support. Actel will not

approve RMA for the failed devices if they exceeded the programming failure guideline.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 32 33

Sin comentarios

Adaptec AVA-1505A Guía de usuario Pagina 11