Adaptec APA-358 Manual de usuario descargar pdf (Pagina 106)

SnapBack Live! 106

Selecting the Backup Drives

After scanning the workstation for hard drives, Dup will

display an option menu on the left side of the screen and a

configuration status display on the right (configuration

settings are discussed in the Chapter “SnapBack For

DOS”).

Select “Backup” from the menu.

Drive Select Menus

Dup will allow selection from “Backup selected

drive/partitions”, “Backup single drive”, or “Backup all

drives”.

Selecting “single drive” will offer a menu of drives on the

system.

Selecting “all drives” will select all attached hard drives on

the workstation.

Selecting “selected drive/partitions” will display a complete

descriptive selection dialog of all drives. Position the cursor

on drives you wish to back up and press the “ENTER” key

to set the backup column to “ON”. This display will show

space at the end of the drive as “Un-partitioneed” which has

not been partitioned. It isn’t necessary to back up these

areas of the drive.

DUP

Tip

If creating model workstations only partition enough drive space

(using FDISK) to hold the operating system and applications. After

restoring the image to the fresh hardware, expand the partition, or use

the additional space as a data drive.

After selecting the partitions to include in the image, press

the <F2> key.

Dup will then confirm that you want to replace the image

file.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 150 151

Sin comentarios

Adaptec APA-358 Manual de usuario Pagina 106