Adaptec ULTRA160 Guía de usuario descargar pdf (Pagina 49)

4-9

Novell NetWare Installation

Using the Load Command Line Options

You can specify several command line options when the driver is

loaded. The available options are described in the table below. This

table describes command line options for the

adpt160m.ham

driver

for Ultra160 products.

adpt160m.ham Command Line Options

Option Values Default Description

auto_disable_tagq= on, off off Enables/disables auto

disable tagged queuing

algorithm.

dev_enable= 0-FFFF FFFF Allows you to enable the

driver's registration of

SCSI devices on a per

target basis. By default, all

targets are scanned. A bit

value of 0 causes the

target not to register

under the operating

system. These devices are

still accessible via ASPI.

This enable bit mask is

entered in hex (see

Bit

Mask Options

page 4-11).

flush_diskreq= 0-FFFF 0 A bit mask to send

occasionally ordered tags

to specific targets. By

default, no targets receive

occasionally ordered tags.

This bit mask is entered in

hex (see

Bit Mask Options

on page 4-11).

instr= on, off off Enables/disables

recording of I/O statistics.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 77 78

Sin comentarios

Adaptec ULTRA160 Guía de usuario Pagina 49