Adaptec ICP5045BL Manual de usuario descargar pdf (Pagina 4)

When using the controller in a Dell Precision 530 with

Diskercise and Diskstress, data corruption/miscompares may

occur.

4.6 ACU utility

On some Intel and IBM systems, when you try to run the ACU,

this message appears:

“Not enough free memory to load the utility!

Press any key to attempt loading the utility forcibly

OR Wait for the system initialization to be completed

[Default]”

This is normal. On Intel systems, wait for the system

initialization to be completed. Then the ACU will run. On IBM

systems, press any key when prompted to load the utility

forcibly.

The ACU /C0 buildall command does not start a build/verify on

RAID 1 or RAID 10 arrays that are being created using the

quick init method.

4.7 FreeBSD

ICP Storage Manager is not supported in FreeBSD; storage

management must be done through the ICP Configuration

Utility (ACU) and ARCCONF command line utility.

4.8 ICP Storage Manager

After a rebuild and waking up from hibernation, a controller

may be detected incorrectly in ICP Storage Manager.

Press F5 to correct the problem.

4.9 ICP5085BR/ICP ICP5805BL/ICP5045BL/ICP5085BL/ICP5125BR/ICP5165BR

controllers

When the controller is installed in PCI-E slot 2 of a

Dell PE 1800 system, there is no BIOS POST.

When the controller is installed in PCI-E slot 3 in a

Dell PE 1800 system, the system halts and the keyboard locks

up.

When the controller is set to boot from a RAID array and a

second RAID array is created, the controller may no longer

be able to find the boot drive.

When the controller is installed in the primary PCIe slot of

an Intel 955X or nVidia nForce4 (Intel edition) motherboard,

if you use the Adaptec Flash Utility to perform a Mode0 flash,

the controller will show incorrectly and cannot be flashed. If

a Mode0 flash is required, install the controller in an

alternate PCIe slot or alternate computer.

4.10 OpenServer 6.0

1 2 3 4 5 6 7

Sin comentarios

Adaptec ICP5045BL Manual de usuario Pagina 4