Adaptec 2100S - SCSI RAID Controller Guía de usuario descargar pdf (Pagina 36)

2-25

Storage Manager on ROM

The Status section displays the current status of the array. A

progress indicator (a numeric percentage of completion) can also

appear if the array is building or rebuilding. The status definitions

are listed below:

SCSI only—The SCSI Capabilities section is a list of controller

capabilities. A check mark next to a feature indicates that the drive

supports the feature.

Setting the Configuration

There are two configuration options on the File menu:

■ Read System Config—Causes SMOR to rescan to detect any

changes in hardware configuration or status. Any changes that

have been made and not saved are lost. This operation is run

automatically when SMOR is started.

■ Set System Config—Causes SMOR to save changes that have

been made to the storage subsystem configuration in the

controller memory. If any array groups or multilevel RAIDs

have been created or modified, this operation causes the

controller to initiate a build operation on the new groups.

Building The array is being built.

Created The array or device is defined, but not initialized.

Dead A Write Back Cache command to the array failed. This

is an unrecoverable failure.

Degraded A single drive in the array failed; array performance is

degraded.

Impacted A verification is being performed on the array; I/O

performance is affected.

Optimal The array is fully functional.

Pending The array has been created and the build is queued on

the controller, but not yet started.

Rebuilding Data is being rebuilt onto a drive in the array.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 134 135

Sin comentarios

Adaptec 2100S - SCSI RAID Controller Guía de usuario Pagina 36