Adaptec 2010S - SCSI RAID Storage Controller Guía de usuario descargar pdf (Pagina 56)

3-15

Storage Manager

1 Select the Create Array Group button. The Select Array Type

window appears, as shown in Figure 3-6.

Figure 3-6 Select Array Type Window

2 Select the desired Fault Tolerance: Drive fault tolerance

(RAID 1 or 5) or No fault tolerance (RAID 0).

3 Select the desired Optimization: Optimize for Capacity

(RAID 5) or Optimize for Performance (RAID 1).

4 As you make your selections, the Chosen Array Parameters

change to indicate which RAID level and stripe size best fit your

selection.

5 You can customize the RAID level and stripe size defaults by

selecting the Override button.

6 Click Continue to select the drives you want to use. The Logical

Configuration View window appears with the caption

Choosing Drives for Array (RAID n), where n is the RAID level

chosen. Select the drives you want to use in the array group as

follows:

a To add drives

■ Click each drive to be added. A green check mark

indicates that a drive is selected.

■ Click Include Drive to add the marked drives to the new

array group. You may need to scroll the window to view

the array group.

b To remove drives

Combined RAID SW-UG.book Page 15 Monday, September 9, 2002 1:25 PM

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 127 128

Sin comentarios

Adaptec 2010S - SCSI RAID Storage Controller Guía de usuario Pagina 56