Adaptec 1210SA - Serial ATA RAID Controller Guía de usuario Pagina 19

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 88
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 18
2-1
2
Installing the Controller
In this Chapter...
Overview
To install the controller and drives, all you need is one or two of
each the following:
■ Serial ATA hard disk drives
■ Serial ATA cables (supplied in this kit)
Configuration of Serial ATA devices is simple for the following
reasons:
■ There are no jumpers or switches to set on the controller or hard
drives.
■ The cable ends are identical, so you don’t need to worry about
which end to attach to the controller and which to the drive.
■ The interface cable connectors, controller connectors, and hard
drive connectors are all keyed so that you can insert them in
only one direction.
Overview 2-1
Installing the Controller 2-2
Checking Your Controller and Devices 2-3
Determining the Boot Controller 2-3
Vista de pagina 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 87 88

Comentarios a estos manuales

Sin comentarios