Adaptec 2200S - SCSI RAID Controller Guía de instalación descargar pdf (Pagina 39)

3-8

Adaptec SCSI RAID 2120S/2200S Installation Guide

WindowsNT4.0

The following driver installation scenarios exist for

Windows NT 4.0:

■ Installing the Driver in a New System on page 3-8

■ Adding the Controller to an Existing System on page 3-9

Installing the Driver in a New System

In this scenario, you are installing an Adaptec SCSI RAID

controller and Windows NT 4.0 in a new system.

Note:

If Windows NT is to coexist with another operating

system, the other operating system must be installed before

you install Windows NT.

To install the driver:

Install and configure your Adaptec SCSI RAID controller and

hard disk drives according to the instructions in Chapter 2.

Start the system, pressing Ctrl-A to enter the BIOS-based

configuration utility. Use the configuration utility to create the

RAID array and logical drive to which you will install

Windows. For details, refer to Creating a RAID 5 Without an

Operating System on page 2-9.

When the array has been built and is finished building, restart

the system. Insert the Windows NT setup CD or disk as you

restart to begin the Windows installation.

Early in the Windows installation, a screen with white text and

a blue background appears after the hardware detection

message, when it appears, press F6

. If you miss pressing F6 in

time, you will need to restart the system.

Note:

You only have 5 seconds to press the F6 key during the

installation startup. Press

at this time; otherwise, you

must restart the Windows installation process to complete

this procedure correctly. Windows will not be able to

recognize the controller and array without the driver.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 66 67

Sin comentarios

Adaptec 2200S - SCSI RAID Controller Guía de instalación Pagina 39