Adaptec APA-358 Guía de instalación descargar pdf (Pagina 7)

APA-358A MiniSCSI-2 Installation Guide

Part Number: 510809-00, Rev. A

Print Spec Number: 493477-00

Current Date: 4/11/95 ECN Date: 4/1195

6 Terminate the last SCSI device attached to the

MiniSCSI-2, referring to the device documentation

for instructions.

7 Disable termination on all other SCSI devices

attached to the MiniSCSI-2, referring to the device

documentation for instructions.

8 To use a parallel printer with the MiniSCSI-2, con-

nect a standard parallel printer cable to the

MiniSCSI-2 printer passthrough connector (see

the following figure). No special configuration or

switching is needed.

9 Check that the SCSI cables are still connected

securely. They may have loosened if you changed

jumper or switch settings on the devices.

10 Turn on the SCSI devices, then turn on the com-

puter. Check the LED on the MiniSCSI-2. If the LED

does not light, you do not have SCSI termination

power. In this case, you must obtain an AC adapter

(see Termination Power on page 4).

Caution: If termination power is supplied by

a SCSI device, do not disconnect the SCSI

device while the computer is on. If you do,

all SCSI devices and any printer connected

to the MiniSCSI-2 stop working. The

MiniSCSI-2 will not recognize the SCSI

devices until you reconnect and turn

ON the

SCSI device and then reboot your computer.

Printer Cable

Printer

Passthrough

Connector

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

Adaptec APA-358 Guía de instalación Pagina 7