Adaptec AHA-2940 - SCSI Card Guía de instalación descargar pdf (Pagina 7)

6 meters (19.7 ft). See your device’s documentation

to determine if it is a Fast SCSI device.

Connecting Internal SCSI Devices

If you are connecting internal SCSI devices, make

sure you have an internal SCSI cable with enough

connectors to accommodate all of your devices.

1 Prepare each SCSI device for installation; config-

ure the device SCSI ID and terminators (terminate

the last internal device attached to the cable). For

instructions, see the device’s documentation as

well as SCSI Configuration Guidelines on page 2.

2 Install the SCSI device in your computer. Refer to

your computer and device documentation for

instructions.

3 Plug the connector at one end of the internal SCSI

cable into the host adapter’s internal SCSI

connector.

Make sure the colored stripe on one side of the

cable is aligned with pin-1 of the host adapter’s

connector. Pin-1 of the connector is usually desig-

nated by a small triangle (

▲), or a “1” on the

connector.

4 Plug the remaining connectors on the cable into

the connectors on the backs of the devices.

Make sure the colored stripe on the cable is

aligned with pin-1 of the device’s connector.

5 Connect a DC power cable (from your computer’s

power supply) to the power connector on the

SCSI device.

Connecting External SCSI Devices

If you are connecting external SCSI devices to your

host adapter, you must obtain an external SCSI cable

for each external device you install.

1 Prepare each SCSI device for installation; config-

ure the SCSI ID and attach a terminating plug

into the last external device. For instructions, see

the device’s documentation as well as SCSI Con-

figuration Guidelines on page 2.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

Adaptec AHA-2940 - SCSI Card Guía de instalación Pagina 7