Adaptec 29160LP - SCSI Card Storage Controller U160 160 MBps Guía de instalación

RINSTALLATIONGUIDEADAPTEC SCSI CARD 29160LPULTRA160 SCSI CONTROLLER29160LPRevA.fm Page 14 Tuesday, May 2, 2000 4:04 PM

9Connect the other end of the external SCSI cable to a SCSI connector on the back of an external SCSI device.If you are installing only one external d

10Double-check for proper SCSI bus termination.To use the Adaptec SCSI Card 29160LP, the card’s driver software must be installed for your operating s

11If you have any problems while installing the Adaptec SCSI Card 29160LP, check the following items first:•Are all SCSI devices powered on?•Are all S

12Copyright© 2000 Adaptec, Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in an

Regulatory Compliance StatementsFederal Communications Commission Radio Frequency Interference StatementWARNING: Changes or modifications to this unit

1The Adaptec SCSI Card 29160LP Ultra160 SCSI controller enables you to connect up to 15 SCSI devices—such as hard disk drives, scanners, and CD-ROM dr

2CHANGING THE BRACKETThe Adaptec SCSI Card 29160LP chips have a bracket designed to fit in low-profile rack-mount server.If you plan to use this card

3Locate an unused 64-bit PCI expansion slot and remove the expansion slot cover. If the computer does not have a 64-bit slot, you can install the card

4Insert the Adaptec SCSI Card 29160LP into the PCI expansion slot. Press down firmly until the card clicks into place; then replace the slot cover scr

5If you want to configure your computer to boot from a SCSI hard disk, make sure the SCSI ID of that hard disk is set to 0. Most SCSI hard disks are p

6You can connect up to 15 SCSI devices to the Adaptec SCSI Card 29160LP. Before connecting devices, be sure to review Setting Up SCSI Devices on page

7Plug the nonterminated end of the cable to the internal LVD/SE connector.Plug the internal devices to the other cable connectors, starting with the c

8Connect a power cable from your computer’s internal power supply to each internal SCSI device.Connecting External SCSI DevicesConnect external SCSI d