Adaptec P2280A Guía de instalación descargar pdf (Pagina 9)

English 5

English

Connecting a SCSI Device

Connecting an External SCSI Device

If you require an external SCSI cable, refer to the table below to find

out which cable to order.

You can purchase these cables from an HP authorized reseller.

An external SCSI device is connected as follows:

1 Assign an unused SCSI ID to the device. SCSI IDs range from 0 to

7 for external devices since it is an 8-bit SCSI bus. The SCSI ID 0

is reserved for the first SCSI hard disk drive and SCSI ID 7 is

reserved for the SCSI controller (the default for narrow and wide

SCSI devices).

The SCSI ID is usually configured with a selector on the rear

panel of the SCSI device. Refer to the Installation Guide

supplied with the device for information on selecting a SCSI ID.

2 Connect the SCSI device to your PC’s external 8-bit SCSI

connector with a shielded SCSI cable.

To connect additional external SCSI devices, daisy-chain each

device to the previous one until all devices are connected.

Ensure that each device is assigned a unique SCSI ID.

For SCSI Device

Order SCSI Cable

Part Number

Description

External Narrow (high density) C2908A, 1 m thumb screw to

thumb screw

HDTS50 to HDT50

External Narrow (low density) K2286, 1 m bail to latch up

K2296, 1m thumb screw to

thumb screw

K2297, 1.5 m thumb screw to

thumb screw

HDTS50 to LDBL50

External Wide C2906A, 2 m thumb screw to

thumb screw

C2907A, 5 m thumb screw to

thumb screw

HDTS50 to HDTS68

p2280a.book Page 5 Thursday, May 17, 2001 5:00 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Sin comentarios

Adaptec P2280A Guía de instalación Pagina 9