Adaptec AHA-3940W Guía de instalación descargar pdf (Pagina 2)

Document Title: AHA-3940/3940W Installation Guide

Part Number: 510595-00, Rev. A

Print Spec Number: 492699-00

Current Date: 8/25/94 ECN Date:08/30/94

Default Setting

AHA-3940/3940W host adapters operate correctly

with their factory default settings in most computers

with PCI slots. The following table lists the settings

and their default values. You can change these set-

tings with the SCSISelect utility. (See Configuring the

Host Adapter on page 6.)

This is a 68-pin connector on the AHA-3940W and a 50-pin connector on the

AHA-3940.

See Termination in Multiple Computer Environments on page 5.

Defaults apply to both SCSI Channels.

Valid only if channel BIOS is enabled.

10 MBytes/sec Maximum Sync Transfer Rate for AHA-3940.

AHA-3940W only.

Location Description

J1 Internal SCSI connector - Channel A

J2 Internal SCSI connector - Channel B

J3 External LED connector

J4 External SCSI connector - Channel A

J5 Multiple computer termination jumper - Channel B

J6 Multiple computer termination jumper - Channel A

Global Settings for Host Adapter and All SCSI Targets Default Setting

Host Adapter SCSI ID 7

SCSI Parity Checking Enabled

Host Adapter SCSI Termination Enabled

Reset SCSI Bus at IC Initialization Enabled

Channel BIOS Enabled

Support Removable Disks under BIOS as Fixed Disks

Boot Only

Extended BIOS Translation for DOS Drives > 1 GByte

Enabled

BIOS Support for More Than 2 Drives

Enabled

Individual Settings for Each SCSI Target Default Setting

Initiate Sync Negotiation Yes

Maximum Sync Transfer Rate 20 MBytes/sec

Enable Disconnection Yes

Send Start Unit SCSI Command

Include In BIOS Scan

Yes

Initiate Wide Negotiation

Yes

1 2 3 4 5 6 7 ... 11 12

Comentarios a estos manuales

Sin comentarios

Adaptec AHA-3940W Guía de instalación Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Tarjetas de interfaz / adaptadores Adaptec AHA-3940W