Adaptec RS Series Guía de usuario descargar pdf (Pagina 34)

3-10

Cabling and Configuration

Connecting a Power Source

This disk shelf is available in an AC power source configuration. The following

sections describe how to connect the power source to the disk shelf.

Connecting an AC Power Source

Figure 3-6. Location of AC power receptacle

1. Ensure the power switch on the disk shelf is in the off position.

2. Connect both the power cords to the disk shelf by inserting the power cords

into the power receptacles on the rear of the disk shelf (see ).

3. Plug the other end of the power cord into a properly grounded AC power

source.

4. Turn on the power switch to power up the system.

Fuses

There are two fuses located on the Power Module of the AC systems. The fuse

can be accessed by using a screwdriver to open the fuse cover.

WARNING: Ensure the power switch is set to OFF and the power cords

removed before opening the fuse covers.

The fuse must be rated for 16 AMPS.

Mute

Temp

SCSI Out

SCSI In

LV D

PSU 1

PSU 2

PSU 1

AC Power

Recepticles

VEM

Host

Shelf

2 0/1 12

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 50 51

Sin comentarios

Adaptec RS Series Guía de usuario Pagina 34