Adaptec 29320A Guía de instalación

ADAPTEC SCSI CARD 29320AINSTALLATION GUIDEASC-29320A IG.fm Page 0 Tuesday, July 29, 2003 3:30 PM

92 Connect the other end of the cable to a SCSI connector on the back of an external device. If you are installing only one external device, terminate

10More Information About TerminationThe last SCSI device on the end of each SCSI bus cable must be terminated, and termination must be disabled for al

11Preloaded Adaptec DriversIf the Adaptec SCSI Card 29320A was included as part of a computer system you purchased, the system already has the appropr

12Regulatory Compliance StatementsFederal Communications Commission Radio Frequency Interference StatementWARNING: Changes or modifications to this un

Canadian Compliance StatementThis Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.Cet appa

1IntroductionThe Adaptec SCSI Card 29320A enables you to connect up to 15 Low Voltage Differential (LVD) and/or 15 Single-Ended (SE) SCSI devices—such

2Installing the Adaptec SCSI Card 29320A1 Discharge any static electricity build-up before handling your SCSI card by touching a grounded metal object

3Computers may have vertical or horizontal expansion slots. Refer to your computer manual to locate the PCI/PCI-X slots. If your computer is a tower m

4Following are some guidelines for setting SCSI IDs and termination on your devices. Check the SCSI IDsThe Adaptec SCSI Card 29320A and each device yo

5Connecting Internal Ultra320/160 and Ultra2 DevicesA special 68-pin internal LVD cable is needed to connect internal Ultra320/160 or Ultra2 SCSI devi

62 Plug the nonterminated end of the cable(s) to the internal LVD connector.3 Plug the internal Ultra320/160 and Ultra2 SCSI devices to the other cabl

7Connecting Wide SCSI DevicesConnect internal Wide SCSI devices to the 68-pin internal SE Wide SCSI connector. To do this, use a 68-pin Wide SCSI cabl

82 Plug one end of the cable to the 50-pin internal SE Narrow SCSI connector on the Adaptec SCSI Card 29320A. 3 Plug the other end of the cable to a t